Thanks, Ernesto ---------- Forwarded message --------- From: Alan Condit <condit.a...@gmail.com> Date: Mon, Jan 23, 2023 at 10:52 AM Subject: Re: [Emc-users] Linuxcnc debs for RPi4 To: ERNESTO LO VALVO <ernesto.lova...@unipa.it>
Thanks, I'll check them out. I had just found the arm64 Bullseye linuxcnc dist. I must have asked the question wrong :-). I played hobb trying to get one of the PCs to compile LinuxCNC 2.9 but I finally succeeded. So I was hoping that I could avoid having to compile 2.9 on my RPi4. Although I have done it several times including building a preemptRT kernel. I have three machines running Linuxcnc and two RPi4s running Linuxcnc and two PCs running Linuxcnc. I have been trying to get them all running Debian Bullseye so that it is less confusing to me when I switch from one to another. I really didn’t want to run Bookworm at the moment. I am tired of bleeding edge. I think I damaged the parallel port on one of my PCs. I know I burnt out the BOB but I replaced the BOB but it is still having issues. So I am planning to replace it with the 2nd RPi4 with a 7C81. The other RPi4 is running a 7i76E. Thanks, Ernesto. On Mon, Jan 23, 2023 at 9:18 AM ERNESTO LO VALVO <ernesto.lova...@unipa.it> wrote: > > For armhf > http://linuxcnc.org/dists/bullseye/2.9-rtpreempt/binary-armhf/ > > For arm64 > http://linuxcnc.org/dists/bullseye/2.9-rtpreempt/binary-arm64/ > > ------------------------------ > *Da:* Alan Condit <condit.a...@gmail.com> > *Inviato:* domenica 22 gennaio 2023 20:30 > *A:* Emc-users@lists.sourceforge.net <emc-users@lists.sourceforge.net> > *Oggetto:* [Emc-users] Linuxcnc debs for RPi4 > > Does any one have debs for installing linuxcnc for Raspberry Pi4 on Debian > Bullseye? > Alan > > _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
