i have a bad habit you might try. Wiggle the connections. Unplug the PC. Don't just turn it off. Some of these setups have the ribbon connectors to the mesa card mashed up against a display card in the next slot. if those connectors are exposed all you have to do is pry the ends of the connector out about 50 thousandths and press them back. Then loosen the screw holding the mesa card into the pci slot and slip the card out a bit and then back in. Now move to the Mesa breakout boards and do the same with those ribbon connectors. Power up the pc and start emc as you usually do. if it fails again compare error messages and get back to us.
I'll do a bit of digging here. > This config uses a 5i23- > Yes we left it up last night-We usually do, but not always. > > > > ------------------------------ > > Message: 2 > Date: Fri, 27 Jan 2023 11:29:30 -0600 > From: "Ray Henry" <rehe...@fast-air.net> > To: "Enhanced Machine Controller \(EMC\)" > <emc-users@lists.sourceforge.net> > Subject: Re: [Emc-users] Not Starting > Message-ID: > <aaef97132469cb79113f6c60813c772d.squir...@mail.fast-air.net> > Content-Type: text/plain;charset=iso-8859-1 > > > The output suggests that you upgraded from LINUXCNC 2.6.32-122 to LINUXCNC > - 2.7.14 about five years ago and now it is trying to find a realtime > kernel > module that did not exist in the earlier install Do you leave this > controller running all the time? There is some discussion about this in > the > 2.7.14 getting started files that might help. Is this a motherboard > parport > or an add in? > > >> I could use some help here. Machine was fine yesterday, power outage >> last night took the machine out. I was never that good with the >> backend stuff and 8 years or so later I'm stuck trying to remember >> what I didn't know. Any help would be apprecieated. >> >> Cinci12mo@cinci12mo:~$ linuxcnc >> LINUXCNC - 2.7.14 >> Machine configuration directory is '/home/cinci12mo/linuxcnc/configs' >> Machine configuration file is 'MEANGREEN.ini' >> Starting LinuxCNC... >> (time=1674826242.755098,pid=6155): Registering server on TCP port 5005. >> (time=1674826242.755202,pid=6155): running server for TCP port 5005 >> (connection_socket = 3). >> iocontrol: machine: '12MO' version 'unknown' >> Found file(REL): ./12mogmoccapymaster.hal >> ./12mogmoccapymaster.hal:3: Can't find module 'probe_parport' in >> /usr/realtime-2.6.32-122-rtai/modules/linuxcnc >> Shutting down and cleaning up LinuxCNC... >> >> >> Jeff Johnson >> john...@superiorroll.com >> Superior Roll & Turning >> 734-279-1831 >> >> >> > ****************************************** > > > > > > _______________________________________________ > Emc-users mailing list > Emc-users@lists.sourceforge.net > https://lists.sourceforge.net/lists/listinfo/emc-users > _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
