Could you try it without I3.000? On Wed, Jun 14, 2023 at 2:31 PM John Dammeyer <jo...@autoartisans.com> wrote:
> Does your spindle have an encoder and the spindle at speed? > > > https://forum.linuxcnc.org/38-general-linuxcnc-questions/43124-g33-1-rigid-tapping > > > -----Original Message----- > From: Nicklas SB Karlsson [mailto:n...@nksb.eu] > Sent: June 14, 2023 12:14 PM > To: emc-users@lists.sourceforge.net > Subject: [Emc-users] G33.1 error then g-code file parsed > > I put the lines below into a file: > > � M3 S100 > � G33.1 Z-30.474 K0.8 I3.000 > � M5 > � M2 > > Then I read into Linuxcnc I get error message: > > � parse_file interp_error > > Removing the line with G33.1 then no error message so it is something > with this row. Program do however execute as expected with G33.1 line > even though there is an error message so no real problem. Also execute > without an error message if run manually in MDI mode. Use origin/master > last commit Mon May 8 16:10:03 2023 +0200 > 404aa407f136ce91a3e6bf911c7bda54011a74e9 Anybody else had similar problem? > > > Nicklas Karlsson > > > > _______________________________________________ > Emc-users mailing list > Emc-users@lists.sourceforge.net > https://lists.sourceforge.net/lists/listinfo/emc-users > > > > _______________________________________________ > Emc-users mailing list > Emc-users@lists.sourceforge.net > https://lists.sourceforge.net/lists/listinfo/emc-users > _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
