I have had good luck with the 4 but haven't updated it recently.. It seems maybe to be on the edge graphics wise - I would think the 5 would be perfect.. (if the latency is good)
On Tue, Apr 9, 2024 at 12:35 PM gene heskett <ghesk...@shentel.net> wrote: > On 4/9/24 12:50, John Dammeyer wrote: > > Hi all, > > > > Will the Pi5 be any better for LinuxCNC than the Pi4 with a MESA > Ethernet > > Controller or is the Pi4 already more than what LinuxCNC requires? > > > > John > I am running a late 1940's Sheldon 11x54 first with an rpi3b, but its > tongue was dragging on the floor, and I've not seen any evidence of that > since switching to an rpi4b not long after it came out. > > I did put many of the "manual functions" in a separate 200 hz thread > while it was still running of the 3b, and have not taken any of it out > since swapping in the rpi4. My .hal file is available, just ask, for a > 7i90HD & a triplet of 7i42TA's to anyone who asks. It uses a Spinx1 to > talk to the vfd. This leaves the ethernet free to tend to the usual > network stuff. Like updating the os or even browsing you-tube. > > > > > > _______________________________________________ > > Emc-users mailing list > > Emc-users@lists.sourceforge.net > > https://lists.sourceforge.net/lists/listinfo/emc-users > > . > > Cheers, Gene Heskett, CET. > -- > "There are four boxes to be used in defense of liberty: > soap, ballot, jury, and ammo. Please use in that order." > -Ed Howdershelt (Author, 1940) > If we desire respect for the law, we must first make the law respectable. > - Louis D. Brandeis > > > > _______________________________________________ > Emc-users mailing list > Emc-users@lists.sourceforge.net > https://lists.sourceforge.net/lists/listinfo/emc-users > _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
