I'm unfamiliar with G10 commands or how they would apply to this. I read over
the documentation on them and don't quiet understand how they would work for
this.
On 4/20/24 6:59 AM, andy pugh wrote:
On Sat, 20 Apr 2024 at 02:12, Billy Huddleston via Emc-users
<emc-users@lists.sourceforge.net> wrote:
> However, When
you touch off a part, you nuke out your Original G54, or G55 locations.
It might help to consider that the various touch-off commands in the GUIs just
run various versions of the G10 command behind the scenes.
So you could set up buttons to reset the axes or tool table.
--
atp
"A motorcycle is a bicycle with a pandemonium attachment and is designed for the
especial use of mechanical geniuses, daredevils and lunatics."
— George Fitch, Atlanta Constitution Newspaper, 1912
_______________________________________________
Emc-users mailing list
Emc-users@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/emc-users
