On 11/19/26 21:11, Viesturs Lācis wrote:
I am sorry but I think I do not understand what you mean.
ceturtd., 2026. g. 19. nov., plkst. 17:48 — lietotājs andy pugh
(<[email protected]>) rakstīja:.
Does the execution of the remap routine fall off the end of the
routine in the case of those two tool numbers?
try master, you are using large pocket numbers, which is broken in 2.9.
I have retrofited a machine like yours, and I did the toolchanger
entirely in HAL, and XY offsets in the tooltable:
https://github.com/rene-dev/linuxcnc-configs/blob/master/maw/tools.comp
IMHO the fact that the command runs correctly in MDI tells me that
those routines are defined correctly.
Anyways, here is the main file: tool_change.ngc https://pastebin.com/TWXAzFcL
Here is the routine that unloads current tool: tool_put_move.ngc:
https://pastebin.com/gkYMbez2
Here is the routine that loads new tool: tool_get_move.ngc:
https://pastebin.com/wGiZH68c
Is there anything special about them? A specific alternate toolhead,
for example?
First 7 tools are on a servo-driven carousel that is engaged with
spindle by pneumatic cylinder. Tools 51-82 are drills that are on a
separate gang-drill block - driven all together by motor and just
extended to working position with pneumatic actuator, something like
this (you can seem main spindle on the edge of picture):
https://encrypted-tbn0.gstatic.com/images?q=tbn:ANd9GcTYOTbF55C322qtjtLB5onQ9r2XyTjfCcEXDh66wM6SZA&s=10
Let me know if you want to see the config as well.
Viesturs
_______________________________________________
Emc-users mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/emc-users
_______________________________________________
Emc-users mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/emc-users