On 03/07/2014 17:57, Jukka Jylänki wrote:
> Not sure then. Perhaps Sathya has encountered the root issue before
> and has a pointer to give. You can also try doing set EMCC_DEBUG=1 and
> set EM_BUILD_VERBOSE=3 to make the run as noisy as possible, perhaps
> that can give a hint on what command is being run. Try pasting that
> output to Sathya in case he has seen the issue.
Thanks. I tried those too, i.e. I added
-s EMCC_DEBUG=1 -s EM_BUILD_VERBOSE=3 -s EM_SAVE_DIR=1
to the emcc command to link my .o files. There is no additional output.
The emcc.bat command is echoed (because I have that set in vs-tool) and
then the error appears. Yes I am sure I have set these on the correct
invocation of emcc because if I omit "=n" from one of them, I get the
warning message.
Hope Sathya can help.
Regards
-Mark
--
注意：この電子メールには、株式会社エイチアイの機密情報が含まれている場合
が有ります。正式なメール受信者では無い場合はメール複製、 再配信または情
報の使用を固く禁じております。エラー、手違いでこのメールを受け取られまし
たら削除を行い配信者にご連絡をお願いいたし ます.
NOTE: This electronic mail message may contain confidential and
privileged information from HI Corporation. If you are not the intended
recipient, any disclosure, photocopying, distribution or use of the
contents of the received information is prohibited. If you have received
this e-mail in error, please notify the sender immediately and
permanently delete this message and all related copies.
--
You received this message because you are subscribed to the Google Groups
"emscripten-discuss" group.
To unsubscribe from this group and stop receiving emails from it, send an email
to [email protected].
For more options, visit https://groups.google.com/d/optout.
