This is from my N7: router vrrp create vlan 106 2 address vlan 106 2 10.205.106.1 0 master-icmp-reply vlan 106 2 enable vlan 106 2
Is there a similar "master-icmp-reply vlan 106 2" command on the A/B/Cs? Thanks, Lou Goddard Network Engineer 302-552-8053 [email protected] From: Lamine b <[email protected]> Sent: Wed, 11/3/2010 11:47am To: Enterasys Customer Mailing List <[email protected]> Subject: [enterasys] PB Pinging VRRP virtual interface Hi, I've configured VRRP on 2 C3 which are connected Access switch (A2&B3). VRRP works fine and I can reach servers outside the LAN. The problem is that I can't ping the VRRP virtual interface (neither form a PC which is configured with a default gateway as the VRRP virtual interface nor from the C3 which is a master router nor from any other switch/router) Is that normal??? should I activate anything? with Cisco it works fine and I can ping the virtual interface. Thanks for your help. Regards, Lamine --To unsubscribe from enterasys, send email to [email protected] with the body: unsubscribe enterasys [email protected] ------------------ CONFIDENTIALITY NOTICE --------------- This message, including any attachments, is for the sole use of the intended recipient(s) and may contain privileged confidential information protected by law. Any unauthorized review, use, disclosure or distribution of this message is prohibited. If you are not the intended recipient, please contact the sender by reply e-mail and destroy all copies of this message. ------------------ CONFIDENTIALITY NOTICE --------------- --- To unsubscribe from enterasys, send email to [email protected] with the body: unsubscribe enterasys [email protected]
