Hey guys, need a little bit assistance to configure vlan to policy. Can´t found any tutorials on extranet to setup this feature. Has any one a manual?
I take the follow steps: [Policy Manager] 1. create a role and setup the tab "Vlan Egress with Vlan 100" [NAC] 1. create a rule "Rule Name" -> Authentication is MAC and End-System is in "End-System-Group" + New Nac Profile 2. Nac Profile with created Accept Policy (with Vlan 100) After the enforce and authentication, the port has two vlans, Vlan 100 an default vlan. Thats my problem, i want only the 100 Vlan on this port not the default vlan. If i setup the port manualy to a other vlan (400), i have the same problem. My Vlan 100 will added to the primary vlan on the port. Whats my mistake? Short Example: VLAN: 1 NAME: DEFAULT VLAN VLAN Type: Default Egress Ports ge.1.4[Test Notebook], ge.1.48 [Uplink] Forbidden Egress Ports None. Untagged ports ge.1.4[Test Notebook], ge.1.48[Uplink] VLAN: 100 NAME: xXXx VLAN Type: Permanent Egress Ports ge.1.4[Test Notebook], ge.1.48 [Uplink] Forbidden Egress Ports None. Untagged ports ge.1.4[Test Notebook] Example 2: VLAN: 100 NAME: xXXx VLAN Type: Permanent Egress Ports ge.1.4[Test Notebook], ge.1.48 [Uplink] Forbidden Egress Ports None. Untagged ports ge.1.4[Test Notebook] VLAN: 400 NAME: xxxxx VLAN Type: Permanent Egress Ports ge.1.14 Forbidden Egress Ports None. Untagged ports ge.1.14 Regards Jens --- To unsubscribe from enterasys, send email to [email protected] with the body: unsubscribe enterasys [email protected]
