Do you have policy manager? Since the network is in one subnet, you obviously cannot use ACLs. I suppose you could type the policy commands at the CLI (if the IP addresses are statically assigned and not subject to change) or you could use a software firewall on the machines.
Jimmy Payne Information Systems and Technology Department Network Manager 770-205-4558 -----Original Message----- From: [email protected] [mailto:[email protected]] On Behalf Of Johannsb Sent: Wednesday, September 10, 2014 1:10 PM To: Enterasys Customer Mailing List Subject: [enterasys] Switch B3 - VLANs Hello guys, I have two switches Enterasys and four computers as below: switch 1 - Enterasys B3 with: Computer A in port ge.1.1 Computer B in port ge.1.2 switch 2 - Entreasys B3 with: Computer C in port ge.1.1 Computer D in port ge.1.2 The two switches are linked by port ge.1.48. All computers are in same network 10.0.0.X/255.255.255.0. I need this result: Among Computer A, B and D: comunication it's permited Between Computer A and C: comunication it's permited too But among Computer B, C and D: no comunication it's permited In ohter words: If in machine A I type "ping 10.0.0.A" or "ping 10.0.0.B" or "ping 10.0.0.D" or "ping 10.0.0.C", the result must to be a answer If in machine A or B or D, I type "ping 10.0.0.C", the result must to be no answer If in machine C I type "ping 10.0.0.A", the result must to be a answer If in machine C I type "ping 10.0.0.B" or "ping 10.0.0.D", the result must to be no answer The question: I tried to create a VLAN for machines A, B e D and other for C, but the result it isn't the above. What I have to type in each switch for get the objective with success? Tranks, Rogerio --- To unsubscribe from enterasys, send email to [email protected] with the body: unsubscribe enterasys [email protected] --- To unsubscribe from enterasys, send email to [email protected] with the body: unsubscribe enterasys [email protected]
