----[Please read http://ercoupers.com/disclaimer.htm before following any advice in this forum.]----
Had the same problem when replacing mine. What helped a lot was heating it up with Mom's iron to soften while lifting it with a smooth edge (not sharp) putty knife. This worked fairly well. Hope it helps ya. See y'all at Knoxville next week. JoeC 99621 ps----Hey Dennis, is your bird out of the paint shop yet??? Afternoon all, > > I have a small problem and am hoping someone has found an easy way. I went > to change the wing walks on 904. One side was an old sandpaper material > and paint. It came right off. The other side is some type of plastic > material. This stuff will not come off. I have tried three types of paint > striper and one type of adhesive remover. I have used two quarts of > striper. The best any of them does it to let me pull off strips about > one-eighth inch by one inch at a time. The striper seem to work a little > under the edge of the walk. With about four square feet of wing walk, I > would like to find a faster way. > > Since the new walk is narrower than the old, I would prefer not to use a > razor blade because I am going to have polish the area not covered by the > new walk. 904 is not painted. > > Any ideas? > > Richard > N99904 > > > ========================================================================== == == > To leave this forum go to: http://ercoupers.com/lists.htm > Search the archives on http://escribe.com/aviation/coupers/ > > ========================================================================== ==== To leave this forum go to: http://ercoupers.com/lists.htm Search the archives on http://escribe.com/aviation/coupers/
<<attachment: winmail.dat>>
