----[Please read http://ercoupers.com/disclaimer.htm before following any advice in this forum.]----
I went out and measured the trim wire on my Alon and ended up poking a hole
in my finger, but I measured .060". could this be the reason I can never seem to
get the trim exactly right?
Wayne Woollard
----- Original Message -----From: [EMAIL PROTECTED]Sent: Saturday, September 20, 2003 4:07 AMSubject: Re: [COUPERS-TECH] Trim wire----[Please read http://ercoupers.com/disclaimer.htm before following any advice in this forum.]----If the outer casing is rusty, better to replace it.... using a smaller wire leaves some slack in the system.....making it hard to adjust the trim to a desired angle...A properly sized inner/outer bowden (sp?) cable system has virtually no slack.Harry============================================================================== To leave this forum go to: http://ercoupers.com/lists.htm Search the archives on http://escribe.com/aviation/coupers-tech/
============================================================================== To leave this forum go to: http://ercoupers.com/lists.htm Search the archives on http://escribe.com/aviation/coupers-tech/
