----[Please read http://ercoupers.com/disclaimer.htm before following any advice in this forum.]----
Norm. I found that the hardware for assemblies like the "Bellcrank assembly-control elevator-rear" listed as figure 21, number 27 are generally not shown in the drawing for that figure in the parts catalog (Ercoupe) but in discussions with Univair, I was advised that all of the hardware parts for such an assembly would be listed 'generally' immediately following the assembly listing. For the Bellcrank assembly-control elevator-rear the catalog shows: Bolt - AN4-5 Qty 4, nut - AN310-4 Qty 4, Pin cotter - AN380-2-2 Qty 4, Washer AN960-A416L Qty 4, along with the Bushing (book says Elevator bushing but it is actually the rudder bellcrank bushing.). I have found this to be very correct and have replaced every single fastener in the coupe during the restoration. I do not buy them from Univair because of the high price you pay for their handling. The introduction and ordering page ( page II ) in my catalog describes the above group assembly parts list sequence. Hope this helps. Rich Blair Kingsland, Georgia ========================================================================== ==== To leave this forum go to: http://ercoupers.com/lists.htm Search the archives on http://escribe.com/aviation/coupers-tech/
<<attachment: winmail.dat>>
