----[Please read http://ercoupers.com/disclaimer.htm before following any advice in this forum.]----
Tommy,
The Continental Engine Overhaul Manual
has specific instructions for installing propellers on tapered
crankshafts. Propeller
hub bolts: 200-220 inch pounds of torque. The hub nut
for the tapered crankshaft: 200-225 foot pounds. You can
also find bolt torques for
McCauley at their website, check the product support, then active service
bulletins. There you will find the bulletin on the subject "Mounting
Torque". This particular site has other service letters and
bulletins that contain a wealth of information on inspection and service
criteria on your propeller. Great reading.
Walt Uebele
1946 415-C
N94113
From: Tommy Terry [mailto:[EMAIL PROTECTED]
Sent: Wednesday, December 01, 2004 7:52 AM
To: [email protected]
Subject: [COUPERS-TECH] Prop Bolt Torque
----[Please read http://ercoupers.com/disclaimer.htm before following any advice in this forum.]----
We are replacing the prop bolts on
93929 and cannot find the torque values.
I’m sure they are out there somewhere but we
just haven’t found the place yet. This leads to two
questions:
1.
Any ideas on where to find the
information?
2.
Does anybody know the values right
off?
Continental
75/85
Tapered shaft
Thanks
Tommy
============================================================================== To leave this forum go to: http://ercoupers.com/lists.htm Search the archives on http://escribe.com/aviation/coupers-tech/
============================================================================== To leave this forum go to: http://ercoupers.com/lists.htm Search the archives on http://escribe.com/aviation/coupers-tech/
