----[Please read http://ercoupers.com/disclaimer.htm before following any advice in this forum.]----
Slicks have such a good package price available on them usually (if you have tradable cores like Bendix), that in my opinion it's worth just getting new ones. Check with Mattituck for their package price. http://www.mattituck.com/ It will include new impluse coupled mags, harness, plugs and drive gears. I got the complete package for an A65 a year or so ago for about $850 I believe. Slicks have a very good reputation now. roger ----- Original Message ----- From: "Larry Snyder" <[EMAIL PROTECTED]> To: <[email protected]> Sent: Tuesday, April 05, 2005 5:34 AM Subject: [COUPERS-TECH] Magneto woes are back > ----[Please read http://ercoupers.com/disclaimer.htm before following any > advice in this forum.]---- > > > All, > > I had written before that my right mag went bad after a cross country to > Kansas City from St. Clair, MO, about 200 miles. Actually, I think I wrote > that it was my left mag, but it was, in reality, my right one. Executive > Beechcraft put new spark plugs in and installed new breaker points on the > right mag. It seemed OK after that, although the drop on the right mag was > more than the left. > > I was ready to solo Sunday, but noticed a power drop on the takeoff run > and the plane settled back down after climbing a couple of feet off the > runway. I still had lots of room left, so I stopped it and taxied back. I > figured I should do another mag check just to make sure - but this time > the right mag dropped 200 RPM and the left didn't drop hardly at all, > obviously exceeding the 70 RPM the POH calls out as the maximum difference > between mags. So much for my solo. > > I'm waiting for the mechanic to take a look at it (my plane is at a small > field the the mechanic comes out as needed), but it's looking like there > may be a more fundamental problem with the mag. The engine was missing a > bit on the right mag, too. > > So now I'm faced again with the dilemma of whether to rebuild the right > mag or go with Slicks. I was hoping this was a problem I could put off, > but it doesn't look like it. > > I've gotten lots of advice, but it would be interesting to take a poll on > this - what would you do? I would think that if I were to have both mags > rebuilt, it might be better to just go ahead and put new Slicks on. But if > I just have the right rebuilt, that could be much cheaper. > > Thanks, > > Larry > > ========================================================================== ==== > To leave this forum go to: http://ercoupers.com/lists.htm > Search the archives on http://escribe.com/aviation/coupers-tech/ > > > ========================================================================== ==== To leave this forum go to: http://ercoupers.com/lists.htm Search the archives on http://escribe.com/aviation/coupers-tech/
<<attachment: winmail.dat>>
