RE: [COUPERS-TECH] Wing bolts

[Wood, Percy]

----[Please read http://ercoupers.com/disclaimer.htm before following any advice in this forum.]----

Please use caution on this, Charles, because it is from memory.

  The bolt that goes through the ball in the end of the control rod to the ailerons is a standard, AN part.

This is the AN#-#### format; where the first digit after the AN is the bolt size in 1/16^th of an inch.  The one you need is as you describe: castle nut with a cotter pin.  Any A&P rated mechanic should be able to size it out.  Take in the old one and get one just like it.

           Percy

 

---

From: Charles Waldo [mailto:[EMAIL PROTECTED]
Sent: Tuesday, May 31, 2005 1:59 PM
To: Ercoupe Tech
Subject: RE: [COUPERS-TECH] Wing bolts

 

 
----[Please read http://ercoupers.com/disclaimer.htm before following any advice in this forum.]----
 
 

The rod end bearings of the control linkage......not the bellcrank or those huge wing bracket bolts....
 
Chuck

JThomas Terry <[EMAIL PROTECTED]> wrote:







Let?s make sure were talking about the same animal.
 
There is a bolt that goes through the rod end bearing and then there are 4 bolts that hold the bracket to the wing root.  There is also a bolt that goes through the bearing in the bellcrank.  That gives us 6 to choose from.  If you can narrow it down a little, most everyone here can help.
 
Tommy
N93929
 




From: Charles Waldo [mailto:[EMAIL PROTECTED] 
Sent: Tuesday, May 31, 2005 2:47 PM
To: Ercoupe Tech
Subject: [COUPERS-TECH] Wing bolts
 
 
----[Please read http://ercoupers.com/disclaimer.htm before following any advice in this forum.]----
 
 
Guys
 
  I was bolting my wings back on after transporting it to my hanger (under a A&P supervision of course)......and found that a bolt was stripped that holds the control linkage that passes between the outer and inner wing.....it has a castle nut and needs a small cotter pin.....anybody know the part number? Univair says its a standard bolt and they only need the diameter and length...its a 46C model.....remember I'm a newbie...be gentle........
 
  Chuck
==============================================================================
To leave this forum go to: http://ercoupers.com/lists.htm
Search the archives on http://escribe.com/aviation/coupers-tech/




==============================================================================
To leave this forum go to: http://ercoupers.com/lists.htm
Search the archives on http://escribe.com/aviation/coupers-tech/




==============================================================================
To leave this forum go to: http://ercoupers.com/lists.htm
Search the archives on http://escribe.com/aviation/coupers-tech/