Fwd: RE: [COUPERS-TECH] Wing bolts

[Charles Waldo]

Thanks Tom and all who replied....

 

Chuck

Note: forwarded message attached.

--- Begin Message ---

The bolt you need is:  AN3-10

You will also want correct aircraft grade cotter pins and an assortment of thick and thin washers for the AN3 bolt.

 

Tommy

---

From: Charles Waldo [mailto:[EMAIL PROTECTED]
Sent: Tue 5/31/2005 2:59 PM
To: Ercoupe Tech
Subject: RE: [COUPERS-TECH] Wing bolts

----[Please read http://ercoupers.com/disclaimer.htm before following any advice in this forum.]----

The rod end bearings of the control linkage......not the bellcrank or those huge wing bracket bolts....

 

Chuck

JThomas Terry <[EMAIL PROTECTED]> wrote:

Let’s make sure were talking about the same animal.

 

There is a bolt that goes through the rod end bearing and then there are 4 bolts that hold the bracket to the wing root.  There is also a bolt that goes through the bearing in the bellcrank.  That gives us 6 to choose from.  If you can narrow it down a little, most everyone here can help.

 

Tommy

N93929

 

---

From: Charles Waldo [mailto:[EMAIL PROTECTED]
Sent: Tuesday, May 31, 2005 2:47 PM
To: Ercoupe Tech
Subject: [COUPERS-TECH] Wing bolts

 

 
----[Please read http://ercoupers.com/disclaimer.htm before following any advice in this forum.]----
 
 

Guys

 

  I was bolting my wings back on after transporting it to my hanger (under a A&P supervision of course)......and found that a bolt was stripped that holds the control linkage that passes between the outer and inner wing.....it has a castle nut and needs a small cotter pin.....anybody know the part number? Univair says its a standard bolt and they only need the diameter and length...its a 46C model.....remember I'm a newbie...be gentle........

 

  Chuck

==============================================================================
To leave this forum go to: http://ercoupers.com/lists.htm
Search the archives on http://escribe.com/aviation/coupers-tech/

==============================================================================
To leave this forum go to: http://ercoupers.com/lists.htm
Search the archives on http://escribe.com/aviation/coupers-tech/

--- End Message ---

==============================================================================
To leave this forum go to: http://ercoupers.com/lists.htm
Search the archives on http://escribe.com/aviation/coupers-tech/