----[Please read http://ercoupers.com/disclaimer.htm before following any advice in this forum.]----
Hey Larry: The valve can be taken apart, but some times it may have been
damaged by a previous attempt at taking it apart. Usually just a good cleaning
and putting it back together with a little fuel lube will solve the problem. Be
careful when taking it apart, and putting it back together to ensure it is in
the correct position. Also, there should be a small spring washer under the
valve, where the big screw holds it together, to keep it tight. Be sure not to
lose this, or leave it out. Putting it back together without fuel lube may
cause it to leak even more. I have heard of lapping the valve, but if you think
it is necessary, use very fine lapping compound.,
I am not aware of any replacement valve, but talk
to your FSDO, and see what they will approve. I would think that any approved
valve that is the same size should not be a big problem, but then that would be
too easy.
Lynn Nelsen
============================================================================== To leave this forum go to: http://ercoupers.com/lists.htm
