----[Please read http://ercoupers.com/disclaimer.htm before following any advice in this forum.]----
> > From: "Paul M. Anton" <[EMAIL PROTECTED]> > Date: 2006/08/07 Mon AM 01:22:30 GMT > To: <[email protected]> > Subject: [COUPERS-TECH] L.G. Donuts > > I ground a slot in a flat blade screw driver. The slot is the same width as the thickness of the snap ring. You wind up with a two tyned fork looking tool. Then heated the shank of the screwdriver red with a propane torch and put a bend in it so it looked somewhat like a small pry bar. I use one to hold the first end in place (will not slip off the snap ring), Used a friend to hold it there and I used a second one to work the ring into the groove from the other hole. Again it does not slip off. Works nicely. Less cussing. Rich Blair ============================================================================== To leave this forum go to: http://ercoupers.com/lists.htm
|
Here's what I use to compress the donuts.
Once the oleo's are removed I can usually get the new donuts
installed in 30 minutes or so.
Cheers:
Paul
N1431A
 |
