Dennis, Let me correct myself, Lynn is right about the rivets holding in the channels. It was real late lasst night when I typed that and I should have said rivets. But the kit comes with screws too. These are added to the kit so they can be installed under the battery box, so the box does not have to come out. Sorry for the mix up. Mark PS Lynn I have seen them bolted and screwed in also.
--- In [email protected], [EMAIL PROTECTED] wrote: > > Hey Dennis: As pointed out earlier by Richard, the Center section rear spar > reinforcement is covered in Ercoupe Memorandum 53 A. There are two U channels > PN 415-13109 installed under the top web of the rear spar. There should be > approximately 12 rivets on each side on the top of the rear spar that hold the > reinforce-ment channels in place. I have seen some that have used bolts, but > the service memorandum uses AN470AD -4-5 and -6 rivets. These U channels are > located 6 to 8 inches out board of the center and should be easily identified > by running your hand under the top of the rear spar. > Lynn Nelsen > > > > **************Start the year off right. Easy ways to stay in shape. > http://body.aol.com/fitness/winter-exercise? NCID=aolcmp00300000002489 >
