My windows slid out of the slot at the top of the (bubble) windshield channel. It was tight and it took a fair amount of pressure. The instructions for the new welt said to remove the inner panels, but I found that was not necessary after going through the pain of removing one inner panel. The old welting pulled out fairly easily. It had been installed incorrectly, "inside out." The new welting is installed in a way you wouldn't think, with the small felt piece on the outside, away from the window glass. Follow the illustrations with the welt.
I was able to use a flexible pick-up tool with a claw type end to grasp the end of the new welt and guide it down the channel as I pushed it in from the top. I used a "springy" metal yard stick periodically to push the welt into the channel and I spot glued the welt at the bottom end and every six inches or so in the top channel. A few pieces of folded cardboard box held the welt tight to the channel until the glue dried. The new welts seem to work well. Fred Goff 130 Tracy Drive Vernon, CT 06066 (860) 875-4027 (860) 874-6990 (cell)
