I had six chargers in parallel on my S-10 Blazer. I have used ng3, ng5,
pfc-30, pfc-50, and more. As was already posted, when using charging in
parallel, only one charger can be un-isolated. Since ng3 chargers are
isolated, that does not pertain to you.
Assuming you are familiar with adjusting Zivan ng3 chargers and have
set yours correctly, your posted plan to let both do the bulk
charging, where one ng3 stops at a lower set point voltage (~80%SOC?),
and the other ng3 is set to continue to finish the charge.
{brucedp.150m.com}
-
On Fri, Mar 22, 2013, at 05:08 AM, [email protected] wrote:
> Good morning, I am going to run two Zivan NG3's in parallel. Seems to
> be pretty straight forward. My pack is made of 60 Sky Energy, 100ahr
> cells. Charger #1 is set to U1 @ 216vdc and float @ 207vdc. I had
> charger #2 programmed to U1 @ 210vdc and float @ 201vdc. This is to get
> the main charge up to 210vdc with both and let Charger #1 finish and
> balance. Are there any concerns that I should be aware?
-
--
http://www.fastmail.fm - A no graphics, no pop-ups email service
_______________________________________________
UNSUBSCRIBE: http://www.evdl.org/help/index.html#usub
http://lists.evdl.org/listinfo.cgi/ev-evdl.org
For EV drag racing discussion, please use NEDRA
(http://groups.yahoo.com/group/NEDRA)
