Rob,
If I recall correctly, both Zilla and Hairball have a microprocessor and
the two units are interconnected with an unshielded Ethernet cable. I do
not know what type of signals go over the Ethernet cable, whether it is
Ethernet (balanced) signals or asymmetic signals, but in any case both
processors may leak high frequency noise from out of their metal box via
the cable.
So, it could help to use shielded Ethernet cable and connect the shield
to a good ground (frame) as well as making sure that the two metal boxes
have a good ground (if their mounting screws connect the frame then that
is usually sufficient, but I have seen the units mounted on plastic or
wood, which leaves then floating and able to transmit all kinds of
noise.

As Roland said - you can also improve the radio by giving it a cleaner
power directly from the battery instead of local grounds and noisy
power. Another area to make sure is the shielding of the antenna cable,
since it often travels through areas with high noise (dash and engine
bay) to get to the antenna that is mounted on top of a large shield,
such as a fender. This is done for a reason. If the antenna cable shield
is interrupted, the antenna may still appear to work OK-ish but the
radio will pick up much more noise from inside the car.

BTW, my AM radio will fade out when going under overpasses but will
otherwise still pick up stronger AM stations, even while driving my EV.
But I have to confess that I am not using a Zilla.

Cor van de Water
Chief Scientist
Proxim Wireless Corporation http://www.proxim.com
Email: [email protected] Private: http://www.cvandewater.info
Skype: cor_van_de_water Tel: +1 408 383 7626


-----Original Message-----
From: [email protected] [mailto:[email protected]] On
Behalf Of Lee Hart
Sent: Saturday, May 25, 2013 11:37 AM
To: Electric Vehicle Discussion List
Subject: Re: [EVDL] Here's an interesting issue: FM interference BEFORE
motor on

On 5/24/2013 11:41 PM, Rob Trahms wrote:
> FM signal is decent with the ignition in position 1 (where you can
remove
> the key), but position 2 (just prior to ignition) a general static
noise
> starts and grows louder until drowning out the FM signal entirely.
> The working theory I have is that either the Hairball microcontroller
or
> possibly the aux voltage gauge is generating the FM noise (seems
unlikely
> that it would be the TBS e-meter I have, because that is on all the
time,
> even when the ignition is off).

I think you will find that the noise is coming from something with a 
microcontroller in an unshielded box (plastic case, bare board, etc.) It

could also come from one inside a metal box, if the metal box isn't 
grounded, or if the wires coming out of that box are not shielded or 
properly handled so they don't act as antennas.

You should be able to unplug things one at a time until you locate the 
offending device.

-- 
The most dangerous enemy of a better solution is an existing one that
is just good enough. -- Eric S. Raymond
--
Lee A. Hart, http://www.sunrise-ev.com/LeesEVs.htm
_______________________________________________
UNSUBSCRIBE: http://www.evdl.org/help/index.html#usub
http://lists.evdl.org/listinfo.cgi/ev-evdl.org
For EV drag racing discussion, please use NEDRA
(http://groups.yahoo.com/group/NEDRA)

_______________________________________________
UNSUBSCRIBE: http://www.evdl.org/help/index.html#usub
http://lists.evdl.org/listinfo.cgi/ev-evdl.org
For EV drag racing discussion, please use NEDRA 
(http://groups.yahoo.com/group/NEDRA)

Reply via email to