Does anyone know how to get the DMOC out of test mode? I replaced the controller circuit board with a new one I purchased a few years ago. It will NOT communicate to the ccShell. However when I connect to a TTY terminal program and power on to says "test 5 and 6 passed, press r to return" I assume that it is in some kind of a testing mode but do not know how to put it into service. I am hoping that it is a simple "press this key and then that one. Worst case is a PROM that is not loaded, if so, then I guess I am screwed. The manual stops at "if you didn't see ...xyz" then call Azure.
Thanks in Advance, Buddy Mills [email protected] Look mom, no gas. www.evalbum.com/2887 Disclaimer: No animals were harmed or killed in the process of writing this email. Any stories to the contrary are, for the most part, either fictional or greatly exaggerated. _______________________________________________ UNSUBSCRIBE: http://www.evdl.org/help/index.html#usub http://lists.evdl.org/listinfo.cgi/ev-evdl.org Please discuss EV drag racing at NEDRA (http://groups.yahoo.com/group/NEDRA)
