On Mon, 2003-07-14 at 10:19, Ron Hauptfleisch wrote: > I have a Clie SJ22 and I am running Evo 1.4.3 under RH 8. I can make > my Clie work only by doing the following: > 1. Tools->Pilot Settings. This seems to prime gpilotd. > 2. Sync the Clie. It will fail, but don't interrupt it or you > will have to do this step over. > 3. Sync the Clie. This time it will work. > This behavior totally repeatable, 100% of the time. > > The Clie also behaved this way under the previous version of > Evolution. >
I got this behavior under RH8 also. I think it had something to do with the kernel not loading the visor module until you press the hotsync button. If I did a `modprobe visor` before trying to sync it would work the first time. > On Mon, 2003-07-14 at 06:38, Stephen Witkop wrote: > > On Sun, 2003-07-13 at 16:41, Richard Zach wrote: > > > I'm having a weird problem where my Clie NR70 is no longer recognized by > > > gpilotd. It all worked before I upgraded to Evo 1.4.3, but maybe > > > something else broke in the last two weeks. pilot-xfer works fine, > > > syslog reports the Clie when I press the hotsync button, gpilotd is > > > "watching the cradle" but just doesn't do anything when I hotsync. The > > > pilot setup applet also can't get the SyncID and username from the > > > pilot. > > > > > > > Sounds like the same problem I have (see my earlier post). Try starting > > gpilotd after you press the hotsync button, that worked for me. > > -- > > Ron Hauptfleisch <[EMAIL PROTECTED]> -- Stephen Witkop <[EMAIL PROTECTED]> _______________________________________________ evolution maillist - [EMAIL PROTECTED] http://lists.ximian.com/mailman/listinfo/evolution
