On Mon, Jul 05, 1999 at 03:49:32PM +0000, Dan C. Stefanescu wrote:
> I have trouble updating to 6.0. Here are the particulars:
>
> My computer is a Micron Powerdigm Xsu with dual CPUs(Pentium II 300MHz),
>
> Adaptec 2940 UW SCSI controller on which there is a 9G hard disk, an
> Iomega Jaz 2G, a Plextor CDROM 32X and aPlexwriter CDR. There is nothing
>
> on the IDEs. The system is currently running RedHat 5.2. Attempts to
> install RH and/or Mandrake 6.0, either from floppy or from CDROM(which
> is bootable),
> fail very early, before getting to any dialog screens. Here are the last
>
> few lines before the installation freezes:
>
> RAM disk driver initialized: 16 RAM disks of 4096K size
> PIIX4: IDE controller on PCI bus 00 dev 09
> PIIX4: not 100% native mode: will probe irqs later
> ide0: BM-DMA at 0xfcd0-0xfcd7, BIOS settings: hda:pio, hdb:pio
> ide1: BM-DMA at 0xfcd8-0xfcdf, BIOS settings: hdc:pio, hdd:pio
> PCI_IDE: unknown IDE controller on PCI bus 00 device c9, VID=1042,
> DID=3020
> PCI_IDE: device enabled (Linux)
> PCI_IDE: will probe irqs later
> ide2: BM-DMA at 0xfcc0-0xfcc7, BIOS settings: hde:pio, hdf:pio
> ide3: BM-DMA at 0xfcc8-0xfccf
>
>
> Any help will be greatly appreciated.
>
>
> Dan Stefanescu
>
You need the updated lilo.rpm. The old did just that with SMP systems.
tom
--
"Everybody is someone else's newbie" (Marilyn Manson, edited)
Thomas 'tom' Berger, [EMAIL PROTECTED] No spam, no UCE. 'Nuff said.
Get Answers! Visit Mandrake Answers on http://aolmfaq.tsx.org!
