On Sat, 20 Nov 1999, WH Bouterse wrote:
> Axalon said:
> >check the "options sb" line in /etc/conf.modules for a dma16=
>
> /etc/conf.modules:
> alias sound sb
> pre-install sound insmod sound dmabuf=1
> options opl3 io=0x388
> alias midi awe_wave
> post-install awe_wave /bin/sfxload /etc/midi/GU11-ROM.SF2
> options sb io=0x220 irq=5 dma=0 dma16=1 mpu_io=0x330
> <should I attempt to alter the dma16=# ?>
rerunning sndconfig should get every going, to find out whats causeing the
conflict "cat /proc/dma" and see what has "1"
> I have attached the corrupted file but am also inclosing the pertinent
> lines below.
> Basically this is from the original "rpm-save" file from the 6.0 to 6.1
> upgrade.
> (Yes it was an upgrade which at first seemed to go smoothly!)
>
> # Edit the entries below to uncomment out the configuration required.
> # Note that only the first value of any range is given, this may be
> changed if required
> # Don't forget to uncomment the activate (ACT Y) when happy
>
> This is from the corrupt file
> # Edit the entries below to uncomment out the configuration required.
> # Note that only the first value of any range is given, this may be
> changed if
> required
> # Don't forget to uncomment the activate (ACT Y) when happy
>
> This is what I did
> # Edit the entries below to uncomment out the configuration required.
> # Note that only the first value of any range is given, this may be
> changed if
> #required
> # Don't forget to uncomment the activate (ACT Y) when happy
There are two places where this has occured make sure you fixed them both.
> I hope the attached file will stay attached and if it opens up
> increasing the length of this post to the general readers I apologize.
>
> William Bouterse
> Juneau, Alaska
>
>
> William Bouterse
> Juneau, Alaska
--
MandrakeSoft http://www.mandrakesoft.com/
--Axalon
