I've had the same problem with Mdk7.1. I tried to resolve modifying
etc/lilo.conf, but it didn't work.
Eventually, the problem was resolved uptading to Mdk7.2...
Pierre
"chronos ." <[EMAIL PROTECTED]>@linux-mandrake.com on 07/05/97 01:56:27
Please respond to [EMAIL PROTECTED]
Sent by: [EMAIL PROTECTED]
To: [EMAIL PROTECTED]
cc:
Subject: [expert] ram issue
Hi all,
I am using mandrake 7.1 and I have 128 of ram.Problem is mandrake only sees
64 of my 128. I went to mandrakeuser.org and found the following. It says
to edit the following- /boot/grub/menu.1st as root and "find" the
following- kernel (hd0,5)/vmlinuz root=/dev/hda6 Then append mem=128 to the
end of the line. So then, how do I "find" the previous line ? I understand
I can use pico to edit the line and all that.I just dont know how to "find"
the line I need.
Thank you, Chronos.
_____________________________________________________________
Email your boss can't read - sign up for free disinfo.net email
at http://www.disinfo.com, your gateway to the underground
**************************************************************************
This message may contain confidential information and is intended solely
for the use of the addressee. If you are not the intended recipient of
this message, please notify the sender immediately and do not disclose,
use, disseminate or copy this message.
The information contained in this message is subject to Systemat's
General Terms and Conditions. Any personal opinion expressed in this
message reflects the opinion of the sender and not Systemat's opinion.
**************************************************************************
$RFC822.eml
