Hi...
Thanks for pointing me to this article. I do seem to be making some progress
by using HP's PPD for my 4050. However, I'm not quite there. Two problems
persist...
1. Under some circumstances I get Courier on my print job where Konqueror's
default Serif font is being used in the browser. (My default Serif font is
the MS TrueType font, Georgia). If my browser can display it, why can't my
printer print it?
An example of this is the URL in your original message below. The body
text is being displayed in Georgia but prints as Courier.
2. Again in Konqueror, the top and bottom margins are screwed up. The top
half of the last line prints at the bottom of one page and the bottom half
prints at the top of the next.-- it's as though the printer is simply not
aware of a top / bottom margin and is just printing continuously.
I do a lot of printing from Konqueror so I'd really like to figure this
out.
Thanks again.
M.
On Tuesday 09 January 2001 06:18, you wrote:
> Michael O'Henly wrote:
> > This sounds a bit like what I get when I use the CUPS "HP LaserJet 4050,
> > Foomatic + stp-4.0 (GIMP-Print)" driver for my HP LaserJet 4050. I've had
> > very little success with any of the CUPS 4050 drivers and I'm using
> > "Generic Postscript" now.
>
> To get all out of your HP 4050, proceed as described on
>
> http://www.mandrakeuser.org/hardware/hcups2.html#instpostscript
>
> Till
--
Michael O'Henly
TENZO Design
