Thanks for the suggestions guys. I got it working last night. Here is what
I did.
I already had it installed, created a spare boot disk. I then edited the
lilo and fstab on the boot disk to point to /dev/hde. Then I shutdown the
system, connected the drives to the controller and powered up. The system
booted from my boot disk! I then edited lilo.conf and fstab to use
/dev/hde, ran lilo and reboot. Worked like a charm!
It has been up for about 9 and a half hours now. I running three instances
of setiathome to test it's stability, so far so good! Any one know of any
other ways I can test the stability? Thanks in advance,
Cecil
--
This email was routed through The Twilight Zone.
