-----Original Message-----
From: [EMAIL PROTECTED]
[mailto:[EMAIL PROTECTED]]On Behalf Of David Rankin
Sent: Friday, January 26, 2001 2:04 PM
To: mandrake
Subject: [expert] Modem at Com 2 0x02fb IRQ3 - BUT IT CAN'T BE FOUND
Check your /dev/modem softlink and make sure it points to /dev/ttyS1
I.E.
ls -l /dev/modem
If so run minicom and with minicom up type
ATZ
you should get back an OK.
If not type in
ATZ
then
AT&F
and
AT&F1
and
AT&W
and then
ATZ
again.
At some point you should start getting "OK"'s again...
Remember that you might NOT see what you type in until the modem is fully
"reset".
It could be that your modem is not communicating due to software settings or
defaults. USR's are notorious for this.
The above commands resets the modem NVRAM to optimal settings and saves the
defaults...
-JMS
