There is a howto available at:
http://linux-usb.sourceforge.net/SpeedTouch/howto.html
I have used this successfully, with the following caveats:
1. I could only get it to work with the 2.4.4 kernel or an earlier 2.4
version.
2. When you compile the new kernel the howto says "make install_modules"
This should be "make modules_install"
3. You may need to edit the Makefile in the SpeedTouch kernel module so
that the $SARLIB variable contains the correct path to your SARLib.
4. When you try to install the ppp daemon using RPM it may fail, because you
already have a later version installed. However if your ISP uses PPP over
ATM then you must use a pppoatm-aware ppp daemon. To install this from rpm
you may need to use rpm --force
Although I can connect a single machine with the SpeedTouch, I have not been
able to make it work as a gateway/firewall for a whole network.
Regards
Chris
=======================================
Chris Slater-Walker BA(Hons) CCNA CCDA MCSE
Cisco, Windows NT, Linux, Samba, DNS
French & German Spoken
=======================================
[EMAIL PROTECTED]
http://www.slater-walker.net/
==================================
----- Original Message -----
From: "lqlee" <[EMAIL PROTECTED]>
To: <[EMAIL PROTECTED]>
Cc: <[EMAIL PROTECTED]>
Sent: Tuesday, July 24, 2001 6:21 AM
Subject: [expert] Alcatel SpeedTooch USB installation fail
> All,
>
> the Alcatel SpeedTouch USB installation failed.
>
> I think its driver should be built into kernel.
> or make a rpm package.
>
> is there anyone will do it?
>
> Regards,
>
> Lee
> ______________________________________
> ----------------------------------------
> lee,liqun
> [EMAIL PROTECTED]
> [EMAIL PROTECTED]
> ===================================================================
> ������ѵ������� (http://mail.sina.com.cn)
> �����ֻ�����ͷ�����ţ����콱���ʱ���ֻ���
(http://dailynews.sina.com.cn/c/272235.html)
> �����ֻ����Ŷ�������ÿ����¿��ֻ���
(http://dailynews.sina.com.cn/c/266499.html)
>
>
