Can't seem to get my Xircom RBEM56G-100BTX 10/100/56k pcmcia card to work..
The pcmcia howto (http://pcmcia-cs.sourceforge.net/ftp/doc/PCMCIA-HOWTO) says that I should use the tulip driver. When I do so in hardrake autoprob I get a failure and prompted to inter the following settings: tulip_debug (i) may_ierrupt_work(int) rx_copybreak(i) csrd(i) options(1-8i) full_duplex(i) Any help in what vaules I should set these to would be greatly appreciated (by the way this is an HP omnibook 2150 P2 128mb ram new 8.1 install from cd kernal2.4.8-26mdrk to be patched after I can get online with id dammit!) TIA, Greg _________________________________________________________ Do You Yahoo!? Get your free @yahoo.com address at http://mail.yahoo.com
Want to buy your Pack or Services from MandrakeSoft? Go to http://www.mandrakestore.com
