First of al thank you very much for your response.
> > I have this monitor LG FLATRON 795FT+, and is able to have a resolution
> > of 1024x768 at 100 Hz.
> >
> > In fact under Xfree86 3.3.6 it works in that way.
> >
> > But under Xfree86 4.2.0 it only works at 85 Hz.
> It seems X4 defaults to 85 Hz max for all modes and the default config
> contains no modelines for default modes. If you want different timing
> you can try copying modelines from XF86config to XF86Config-4 or writing
> your own.
Ok, nothing new for me here, but doesn't matter, thanks!
> >
> > I amn using a MDK 8.2, and this monitor is not recogniced by the X
> > wizard, so i have to put it as a generic monitor with similar refresh
> > times.
> Does it appear in the list of monitors? If so, you should select it
> there. Otherwise you can set the capabilities in /etc/X11/XF86Configi-4. It
> should include de cumentation or you can have a look at man XF86Config.
No, the monitor doesn't appear in the list of monitors.
> >
> > My graphics card is a TNT2 M64 (PixelView All-in-ComboTV 128) with 32
> > MBs, so this is not the problem. The problem is in the program that
> > configures the refresh.
> Do both your card and monitor support DDC? If so, the monitor should be
> detected but often it is not.
Yes, both support DDC. But he problem is that XFdrake configure a
default mode of 85 Hz at 1024x768 with XFree86 4.2.0, but i would prefer
100Hz as does XFdrake with XFree86 3.3.6.
And this happens with some friend's monitors.
I can do and i know how, change in XF86config archive, but it would be
better for newbies that XFdrake give more than one option if possible.
So, do you this is something to be commented on cooker or not?
Thank you very much again,
Javier Martinez Villacampa
[EMAIL PROTECTED]
Want to buy your Pack or Services from MandrakeSoft?
Go to http://www.mandrakestore.com
