how many cards doy you have? what is the 10.0.0.0 stuff from? why do you not have the LO interface (loopback) as 127.0.0.1? (you need this, it has no card) and the "host" 192.168.10.20 is where? if you only have one card, you should have a lo (127.0.0.1) and only one eth0 and not an eth1.
On Sunday 09 June 2002 06:25 pm, you wrote: > hi, > > have discovered some problems with a realtec 8139card. > trying to configure with kudzu is okay to trhe point : > "shall I configure your existing configuration " > > typing okay results in a hanging black screen with no ending loop. > > after doing a control-alt-del the system restarts. > > starting again, and make an ignore at same point like above, the systems > starts. doing a configarion by hand like : > > modprobe 8139too loads the module. ifconfig eth1 192.168.10.15 shows a > correct ifconfig. a ping to 192.168.10.15 is also okay, but trying to get a > connection to my remote host 192.168.10.20 results in a > > Destination host unreachable > > the route shows this here : > > Kernel IP routing table > Destination Gateway Genmask Flags Metric Ref Use > Iface 10.0.0.0 * 255.255.255.0 U 0 0 > 0 eth0 192.168.10.0 * 255.255.255.0 U 0 0 > 0 eth1 127.0.0.0 * 255.0.0.0 U 0 0 > 0 lo > > so it seems to be okay. > but why can't I get a connection ? > > have a mdk 8.0 running > > thanks for helping > hans schneidhofer
Want to buy your Pack or Services from MandrakeSoft? Go to http://www.mandrakestore.com
