On 10/06/2002,
The following message was beamed across the Internet:
> hans schneidhofer wrote:
>> > >
>> > > Destination host unreachable
>> > >
>> > > the route shows this here :
>> > >
>> > > Kernel IP routing table
>> > > Destination Gateway Genmask Flags Metric Ref Use
>> > > Iface 10.0.0.0 * 255.255.255.0 U 0 0
>> > > 0 eth0 192.168.10.0 * 255.255.255.0 U 0 0
>> > > 0 eth1 127.0.0.0 * 255.0.0.0 U 0 0
>> > > 0 lo
>> > >
>> > > so it seems to be okay.
>> > > but why can't I get a connection ?
>> > >
> Hans, something is really screwy with your setup. You can not have the
> eth1 set to 127.0.0.0. This is a unique ip address for use on the
> loopback device (lo). And you show your lo with no ip address. Let's
> start all over:
> Which device is your external nic? Get it set up with a public
> (internet) address.
> Which device is your internal nic? Get is set up with a private ip
> address for your network (LAN), such as class C 192.168.0.0/16.
> Get your lo device back to ip address 127.0.0.1
> All of the above plus more should be done. Maybe you should go for a new
> install of all network components. You will not have any connectivity,
> TCP/IP or otherwise, until you can get this network stuff fixed...
> Good luck,
Also you cannot end an IP address with 0 it must be at least 1
eg. 10.0.0.1
192.168.10.1
--
Regards,
Mark Van Bruggen
[EMAIL PROTECTED]
There is always a way, it's just reality that's the problem !!
======================================================================
Mark Van Bruggen
Microsoft OEM Certified Phone : 07 4926 4900
Computer Systems Supplier Mobile: 04 3886 4900
Internet / Computer Technician E-mail: [EMAIL PROTECTED]
Rockhampton QLD AU
======================================================================
Want to buy your Pack or Services from MandrakeSoft?
Go to http://www.mandrakestore.com
