I have this printer and apparently had the same problem. It started to work when I downloaded pnm2ppa from sourceforge, compiled and copied the binaries over the mdk ones.
Edu On Fri, 2002-12-27 at 00:11, mycal62 wrote: > have tried these as well and nothing. only has a parallel port. > > something else is obviously messed up , I just can't figure it out. > > may go in and remove all all of cups and related stuff and go back with > the earliest cups and drivers > I can get to work with 9.0 . > > thanks anyway > > I'm assuming , you don't have this model ' 820cse ' running since you > said yours has usb port. > > I was looking for someone who has this EXACT printer working in MDK 9.0, > not general printer help. > > thanks for trying though. ;-) > > Ron Stodden wrote: > > > mycal62 wrote: > > > >> thanks for the reply, but your suggestions failed. :-( > > > > > > Then use the KDE Control Center > System > Printer or printerdrake to > > remove your printer (software). > > > > Then install it again as a new printer with the appropriate driver. > > > > If you are using cups, you can also try as root: > > > > service cups stop > > > > then: > > > > service cups start > > > > My HP printer has both parallel and USB interfaces, so you can try > > using the other interface and install it as a new printer (all > > diffferent software). > > > >------------------------------------------------------------------------ > > > >Want to buy your Pack or Services from MandrakeSoft? > >Go to http://www.mandrakestore.com > > > > -- Eduardo S. Libardi <[EMAIL PROTECTED]>
Want to buy your Pack or Services from MandrakeSoft? Go to http://www.mandrakestore.com
