Look in the "Rubber & Foam Rubber" section...or just search for Part #
8633K3. It is the tan rubber, 40A durometer and comes in a 12 x 12
sheet that is 1" thick. It is smooth on both sides. I think it's the
same material that KBS used to sell for about $10 per puck.
I use a 2-1/8" (OD) hole saw (yields a nice 2" puck) and can get 25
pucks from a sheet. My "secret" is to spray a lot of WD40 while cutting
on the drill press so the rubber doesn't get sticky or hot.
-Jeff B.
Bruce Kapraszewski wrote:
Does anyone know where on the McMaster-Carr website I can find puck material?
Thanks.
Bruce
________________________________
FormulaCar Magazine - A Proud Supporter of Formula 500
The Official Publication of Junior Formula Car Racing
Subscribe Today! www.formulacarmag.com or 519-624-2003
_________________________________
_______________________________________________
F500 mailing list - [email protected]
To unsubscribe or change options please visit:
http://f500.org/mailman/listinfo/f500
*** Please, DO NOT send unsubscribe requests to the mailing list! ***
