Sorry posted to reply instead of new.
Hi, Is there a quick start guide for Fail2ban 0.9-9 on Centos 7 ?
I read (briefly) the man pages for fail2ban-server and jail.conf and
believed it was a simple case (to start off) of rem'ing out the
unrequired jails in the jail.conf and saving as a jail.local in the
jail.d folder.
My problem is that when i have done this and saved my jail.d\jail.local
and then tried to reload fail2ban-client i am getting the following
fail2ban-client reload
WARNING 'ignoreregex' not defined in 'Definition'. Using default one: ''
WARNING 'ignoreregex' not defined in 'Definition'. Using default one: ''
WARNING 'ignoreregex' not defined in 'Definition'. Using default one: ''
WARNING 'ignoreregex' not defined in 'Definition'. Using default one: ''
WARNING 'ignoreregex' not defined in 'Definition'. Using default one: ''
WARNING 'ignoreregex' not defined in 'Definition'. Using default one: ''
WARNING 'ignoreregex' not defined in 'Definition'. Using default one: ''
WARNING 'ignoreregex' not defined in 'Definition'. Using default one: ''
ERROR Failed during configuration: Bad value substitution:
section: [pam-generic]
option : logpath
key : udpport
rawval : ", protocol="udp", chain="%(chain)s",
actname=%(banaction)s-udp]
if (to prove a point) i rem out the offending jail (pam) above, and then
try again, it just does the same error with the previous jail in the
config?? am i missing something?
if i do a fail2ban-client status i get.
fail2ban-client status
Status
|- Number of jail: 0
`- Jail list:
Any advice| links appreciated
Steve
------------------------------------------------------------------------------
_______________________________________________
Fail2ban-users mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/fail2ban-users
