Perhaps the geocoding could be done at the point of entry with afterSave or a dependant ftWatch field. But I haven't had time to take a good look at the plugin, so I don't know if that would fit.
Blair On Wed, Feb 17, 2010 at 10:42 PM, James Buckingham <[email protected]>wrote: > Got it, thanks a lot Phillip, unforunately that one didn't work for us > either. > > Did a bit more research this morning and the issue seems to be the > calls to Google rather than the plugin itself. > > This page goes into more detail.... http://econym.org.uk/gmap/geomulti.htm > > ... but it seems to be down to this multiple calls to Google. If we go > beyond 12 / 13 then we get these messages. We've added delays on each > request but apart from going up to about 4 secs we're not getting the > results back. That's obviously too slow though! > > Like that page recommends we ideally should be doing the call from > ColdFusion, processing the page and inserting the data at the right > points. That means a lot more work from our point of view though so > I've recommended that they look to separate that map out instead. > > Anyway hope that helps anyone else that hits this issue as well ;-). > > Cheers again, > James > > -- > You received this message cos you are subscribed to "farcry-dev" Google > group. > To post, email: [email protected] > To unsubscribe, email: > [email protected]<farcry-dev%[email protected]> > For more options: http://groups.google.com/group/farcry-dev > -------------------------------- > Follow us on Twitter: http://twitter.com/farcry > -- You received this message cos you are subscribed to "farcry-dev" Google group. To post, email: [email protected] To unsubscribe, email: [email protected] For more options: http://groups.google.com/group/farcry-dev -------------------------------- Follow us on Twitter: http://twitter.com/farcry
