But it is here:
Bus 007 Device 006: ID 03f0:3d17 Hewlett-Packard
Are you using the GUI? Did you tell it to look for USB printers (hplip
supports parallel and network printers as well). Sorry for the stupid
questions but the docs say the 1007 is supported.
Yes I do have hplip-gui installed and it does try to look that the USB,
etc..
I really looks like that it is the problem with FC7, because I cannot
install a recent version of hplip, 1.7.4 is too low, it looks that that I
need a 2.8
Get the latest drivers from here
http://sourceforge.net/forum/forum.php?forum_id=851608
And here is the changelog. P1005 was added around 2.8.2 I think,
http://hplip.sourceforge.net/release_notes.html
Thank for the advise.
This it what I did.
but after making make install. the hplip-1.7.4 (rpm) is this here
and I got the errors that I previously mention.
If I remove the rpm hplip.1.7.4 package, and make an install
of hplip.2.8.7, I lost also the hp-setup, etc... commands even after
I reinstall, so I have to reinstall the rpm hplip.1.7.4 !
I do not understand why I cannot get the hp- etc... commands
from hplip-2.8.7.tgz !
Regards
--
---
==========================================================================
Patrick DUPRÃ | |
Department of Chemistry | | Phone: (44)-(0)-1904-434384
The University of York | | Fax: (44)-(0)-1904-432516
Heslington | |
York YO10 5DD United Kingdom | | email: [EMAIL PROTECTED]
==========================================================================
--
fedora-list mailing list
[email protected]
To unsubscribe: https://www.redhat.com/mailman/listinfo/fedora-list
