ethtool result..........
ethtool eth0
Settings for eth0:
Supported ports: [ TP MII ]
Supported link modes: 10baseT/Half 10baseT/Full
100baseT/Half 100baseT/Full
Supports auto-negotiation: Yes
Advertised link modes: Not reported
Advertised auto-negotiation: No
Speed: 10Mb/s
Duplex: Half
Port: MII
PHYAD: 32
Transceiver: internal
Auto-negotiation: off
Current message level: 0x00000000 (0)
Link detected: no
2009/9/12 Jorge Fábregas <[email protected]>
> On Saturday 12 September 2009 02:01:33 pm sureshbabu ct wrote:
> > eth0: 10 Mbit, half duplex, no link
>
> If I remember well..even if the interface drops to half-duplex, you
> shouldn't
> see "no link" on the mii-tool output. Does "ethtool eth0" show no link as
> well? Did you check the LED on the card? Is the port on the switch
> configured auto or manually? That's what I would do...
>
> HTH,
> Jorge
>
> --
> fedora-list mailing list
> [email protected]
> To unsubscribe: https://www.redhat.com/mailman/listinfo/fedora-list
> Guidelines:
> http://fedoraproject.org/wiki/Communicate/MailingListGuidelines
>
--
(¨`·.·´¨) with
`·.¸(¨`·.·´¨) Luv
(¨`·.·´¨)¸.·´ Suresh Vellinezhi.
`·.¸.·´
--
fedora-list mailing list
[email protected]
To unsubscribe: https://www.redhat.com/mailman/listinfo/fedora-list
Guidelines: http://fedoraproject.org/wiki/Communicate/MailingListGuidelines
