>It's actually ABR you're creating, if I understand correctly. Not yet as I am actually outputting 3 multicast streams, each with a set bitrate(1500/3500/6000). They will be captured on the other side of the network and then muxed together to create the ABR stream (a design that, as of yet, cannot be avoided).
>Unfortunately, that preset is a bandwidth hog, and will drop quality >significantly. Actually, it also lowers your profile to "Constrained >Baseline". :-( Bandwidth piece wouldn't be as much of a problem since this is layer2 to the endpoint that will mux them back together but the quality loss and profile change is a problem. If I go to superfast my speed drops to .914 on average. If I understand correctly, this means I am slowing getting farther and farther behind? Will I eventually have an overrun in my fifo buffer causing a reset and lost data? Just double checking my understanding there. Thanks so far for the help so far. Maybe someone else will chime in with the best answer ever! -Jimbo CONFIDENTIALITY NOTICE: This e-mail including attachments is covered by the Electronic Communications Privacy Act, 18 U.S.C. ยงยง2510-2521, is confidential and may contain information that is privileged, confidential or otherwise protected from use and disclosure. If you are not the intended recipient, you are hereby notified that any review, disclosure, copying, or dissemination of this transmission, or taking of any action in reliance on its contents, or other use is strictly prohibited. If you have received this transmission in error, please reply to the sender listed above immediately and permanently delete this message from your inbox. _______________________________________________ ffmpeg-user mailing list ffmpeg-user@ffmpeg.org http://ffmpeg.org/mailman/listinfo/ffmpeg-user To unsubscribe, visit link above, or email ffmpeg-user-requ...@ffmpeg.org with subject "unsubscribe".