gnuplot is up and running. it was necessary to install it from source though, the binaries don't work because libpdf doesn't get installed. i did the sourc-install with fink-commander.
How do i do that on the cl?
thanks for your support.
jc
Am 13.01.2004 um 17:19 schrieb Alexander K. Hansen:
That may indeed be easier. It should go smoothly. -- Alexander Hansen Levitated Dipole Experiment http://www.psfc.mit.edu/LDX
On Jan 13, 2004, at 10:28 AM, jacques couzteau wrote:
after reading Martin Costabels advice. i'd rather do that. i deleted my /sw-directory and am now running the Fink 0.6.2 Installer.pkg
cheerz
jacques
Am 13.01.2004 um 15:59 schrieb Martin Costabel:
On 13 janv. 2004, at 15:21, jacques couzteau wrote:
The version that i can install with dselect or apt-get doesn't run on macos 10.3. It launches but the quits immidiately due to some problems with readlinelib. So the real problem is that when i install gnuplot i get an old version of readlinelib .
Here is what happens when i run the following command: sudo apt-get install gnuplot ... Unpacking gnuplot (from .../gnuplot_3.8h.0-7_darwin-powerpc.deb) ...
This version only runs on OSX 10.1. Since you are on 10.3, you need to go two generations forward in your Fink distribution. In this case, I would strongly advise not to try an update, but to reinstall Fink-0.6.2 from scratch.
When i search for the gnuplot at the fink-webpage i see that the gnuplot-packkage i'm getting comes from an tree 0.4.1.
Yes, and it says "10.1 only".
Since there is also a tree called 10.3-current. i believe my fink install needs an update. so i ran fink selfupdate in the terminal. that exited with errors:
In principle, the selfupdate should work, but there are so many things that can go wrong, and in any case, at least 95% of everything you have in your Fink installation now will have to be replaced by a newer version, so it is more economic to start from zero with a new installation. Don't forget to run selfupdate immediately after having run the 0.6.2 installer. Then the installation of gnuplot from binary should work (version 3.8i.0-16).
-- Martin
------------------------------------------------------- This SF.net email is sponsored by: Perforce Software. Perforce is the Fast Software Configuration Management System offering advanced branching capabilities and atomic changes on 50+ platforms. Free Eval! http://www.perforce.com/perforce/loadprog.html _______________________________________________ Fink-users mailing list [EMAIL PROTECTED] https://lists.sourceforge.net/lists/listinfo/fink-users
------------------------------------------------------- This SF.net email is sponsored by: Perforce Software. Perforce is the Fast Software Configuration Management System offering advanced branching capabilities and atomic changes on 50+ platforms. Free Eval! http://www.perforce.com/perforce/loadprog.html _______________________________________________ Fink-users mailing list [EMAIL PROTECTED] https://lists.sourceforge.net/lists/listinfo/fink-users
