Yes
Guaranteed, or your money back!
Hostmaster
J Weismann wrote:
> you HAVE TO BE KIDDDING!!?!!!?!?! does this really work??
>
> >From: Hostmaster <[EMAIL PROTECTED]>
> >To: "Mail @ faithinchaos.com" <[EMAIL PROTECTED]>
> >CC: [EMAIL PROTECTED], [EMAIL PROTECTED]
> >Subject: Re: Cisco product break-in
> >Date: Tue, 08 Aug 2000 11:49:20 -0700
> >
> >Password Recovery Procedure
> >
> >1. Take a paper clip and straighted it out because
> >we are getting read to pick a electronic lock.
> >2.put a console cable in the back of the 2500/2600
> >3. Put one end of paper clip in the Female connector
> >Pin 2 (Rx pin).
> >4. Locate pin Six (Data Set Ready).
> >5. Power up 2500/2600
> >6. Using paper clip Short pin 2 to pin 6 serveral times (one half second to
> >one
> >second intervals)
> >7. Remove paper clip and Plug Female connector into Lap Top.
> >
> >If you have a problem repeat using pins 2 & 5.
> >
> >Hope this helps - This paper clip Password Recovery goes over
> >real big at a clients work place. "They love it".
> >
> >You should be in the diag mode with a > prompt.
> >Follow normal procedure for recovery.
> >
> >Hostmaster
> >
> >"Mail @ faithinchaos.com" wrote:
> >
> > > Hey,
> > >
> > > I'm trying to break into a misconfigured Cisco 2500 router. I have
> >console
> > > access, but the enable password was lost by someone prior to my arrival,
> >so
> > > breaking in is my only option at this point. Now, I've done this before
> >and
> > > have instructions for the different requirements for different Cisco
> >product
> > > break-ins. My question is this:
> > >
> > > WTF is the break sequence in HyperTerminal (Windoze terminal program)???
> > > CTRL-BREAK doesn't seem to work. Or perhaps I am keying the sequence at
> >the
> > > wrong time during the hard-boot process?
> > >
> > > I also have a Cisco datasheet on different break sequences for different
> > > applications, and none pertaining to Windoze seem to work.
> > >
> > > Its been over a year since I have had to perform this type of procedure,
> >so
> > > I am forgetting something I am sure. Can anyone out there offer some
> > > insight?
> > >
> > > TIA - big time.
> > >
> > > -
> > > [To unsubscribe, send mail to [EMAIL PROTECTED] with
> > > "unsubscribe firewalls" in the body of the message.]
> >
> >-
> >[To unsubscribe, send mail to [EMAIL PROTECTED] with
> >"unsubscribe firewalls" in the body of the message.]
>
> ________________________________________________________________________
> Get Your Private, Free E-mail from MSN Hotmail at http://www.hotmail.com
>
> -
> [To unsubscribe, send mail to [EMAIL PROTECTED] with
> "unsubscribe firewalls" in the body of the message.]
-
[To unsubscribe, send mail to [EMAIL PROTECTED] with
"unsubscribe firewalls" in the body of the message.]
