Title: Message
|
Unfortunately, it never starts flashing. I have
had to reset it before, and it would the test light would flash after a few
seconds after power up. But I have held the button in for almost 5 minutes
with nothing happening.
I just
got a letter back from SonicWall Support and they seem to be under the
impression it is a defective unit.
when you do the reset, be sure that you shut it
off and then power it on with the reset button held in and KEEP holding it
until the light on the front starts to flash. once it's started flashing it
takes just a little while before it stops and then you should be good to
go.
-Z
----- Original Message -----
Sent: Monday, July 02, 2001 11:38
AM
Subject: SonicWall Pro Locked Up
I have recently
been using a SonicWall Pro as an additional firewall on our corporate
network. Yesterday at some time after 12:57pm, it simply locked
up. The Power, Test, and Alarm lights are all solid. I have
tried resetting the device by holding down the reset switch and powering it
on, but nothing happens. I cannot reset the device and install new
firmware.
Does anyone out
there use this device? And if so are you familiar with this happening
often? Is there any way around this, without having to purchase a new
one?
If not, Then I am simply considering
this a 2500.00 Door stop.
|
