[This message was posted by Bivas Mishra of Wipro Technologies <[email protected]> to the "4.0 Session" discussion forum at http://fixprotocol.org/discuss/12. You can reply to it on-line at http://fixprotocol.org/discuss/read/11dac5d7 - PLEASE DO NOT REPLY BY MAIL.]
Hi, I noticed the following in your Seq-Reset message header: "52=1/5/2010 11:13:42" timestamp not in UTC format. Apart from this, are you trying to recover a session by sending a sequence reset? As per FIX4.4 Specs, vol-2, Pg-23, the sequence reset (Reset Mode message should not be used in the scenario you depicted unless it is a disaster recovery scenario. To Quote the specs... "Sequence Reset â Reset should NOT be used as a normal response to a Resend Request (use Sequence Reset â Gap Fill mode). The Sequence Reset â Reset should ONLY be used to recover from a disaster situation which cannot be recovered via the use of Sequence Reset â Gap Fill. Note that the use of Sequence Reset â Reset may result in the possibility of lost messages." Regards, Bivas > LP server send me resend request to send messages( check tag 7 & Tag 16 > ) > > 8=FIX.4.49=8135=249=blabla56=blabla34=138852=20100105- > 05:43:34.1477=8716=010=083 > > I sent sequence reset-reset mode(not gapfill) higher than expected seq > num (plz chaeck tag 36) > > 8=FIX.4.49=5235=449=blabla56=blabla34=8743=Y52=1/5/2010 > 11:13:42123=N36=9110=33 > > but they again gives resend request > > 8=FIX.4.49=8135=249=blabla56=blabla34=138952=20100105- > 05:43:41.8817=8716=010=087 > > How to handle this situation? Thanks in advance. [You can unsubscribe from this discussion group by sending a message to mailto:[email protected]]
-- You received this message because you are subscribed to the Google Groups "Financial Information eXchange" group. To post to this group, send email to [email protected]. To unsubscribe from this group, send email to [email protected]. For more options, visit this group at http://groups.google.com/group/fix-protocol?hl=en.
