Just in case you are wondering why...
although I know I could just split up the sample amount into smaller 512
sample chunks, I am interested in doing some lower latency effects, and
the delay is just too much to bare right now.
On 12/20/2011 3:37 PM, Anthony Pace wrote:
Is this possible?
When recording from the Mic, in this case at 44100hz I can't get the
SampleDataEvent to report sample chunks of less than 2048 samples.
The problem really is that it flash waits about 47 ms on average to
report a sample chunk (although my counter shows it updates between
33ms and 60ms), and in some cases even though there is no load, it
waits until it can report 4098 samples (even though there is no load);
yet, I only need/want 512 samples in approximately 12ms on average.
If, while keeping the same sample rate, there is some official way to
decrease the chunk size being reported and the time it takes to report
it, I can't see it; therefore, I am hoping there may be some way of
just getting to the Sample Data before it's reported?
_______________________________________________
Flashcoders mailing list
[email protected]
http://chattyfig.figleaf.com/mailman/listinfo/flashcoders
_______________________________________________
Flashcoders mailing list
[email protected]
http://chattyfig.figleaf.com/mailman/listinfo/flashcoders
