I'm getting the same error with the rtl8139b board that I used to write to the flash in the first place. I can successfully use the kernel module that ctflash has for flashing rtl8139's
On Fri, May 28, 2010 at 5:49 AM, Michael Karcher <[email protected]> wrote: > Am Freitag, den 28.05.2010, 00:41 -0700 schrieb Kyle Kienapfel: >> Yup, the output looks sensible > I'm afread the output looks like the "write enable" pin of your EEPROM > is not connected to the RTL8139 chip as it would be needed to detect, > erase and write the flash rom chip. As reading just uses the "chip > enable" and "output enable" pins, reading is not a problem. > > This line: >> Probing for SST SST29EE010, 128 KB: probe_jedec_common: id1 0x55, id2 0xaa, >> id1 parity violation, id1 is normal flash content, id2 is normal flash >> content > shows quite clear that the "read ID" command (which is delivered using a > write cycle) does not reach the chip, so it returns the first two data > bytes instead of vendor/product ID. > > Regards, > Michael Karcher > > > _______________________________________________ flashrom mailing list [email protected] http://www.flashrom.org/mailman/listinfo/flashrom
