Chris,
Personally I disagree, if we all know that the transmit default is 50
watts , just have to make sure to have that set before you TX.. Also
there is already a default setting you can change, just go into the SSB
TX profiles after you have already set the power setting and click
Save. By default there is only two. And once you set the Drive
setting in a mode (like CW) the power setting is the same when you
restart PowerSDR. Tune is already defaulted to 10 watts.
73,
Dudley
WA5QPZ
Chris Gerber wrote:
Hi
I noticed some strange behaving in SVN version 3524
If I use the mousewheel to change either RX or TX RIT it does not release
the mousewheel function unless I hit the Start/Stop or VAC ON/OFF
buttons,
the I am able to change the VFO Frequency steps again with my mouse
wheel.
Also some annoyance is the defaul Drive setting of 50.
This can be very dangerous to any Linearamplifier if not watched
(Overdrive) when using
VAC with any Digimode program !
A defaul Drive setting should always be zero (0), and be set accoding
when used.
73 Chris HB9BDM
_______________________________________________
Flexedge mailing list
[email protected]
http://mail.flex-radio.biz/mailman/listinfo/flexedge_flex-radio.biz
This is the FlexRadio Systems e-mail Reflector called FlexEdge. It is
used for posting topics related to SDR software development and
experimentalist who are using alpha and beta versions of the software.
_______________________________________________
Flexedge mailing list
[email protected]
http://mail.flex-radio.biz/mailman/listinfo/flexedge_flex-radio.biz
This is the FlexRadio Systems e-mail Reflector called FlexEdge. It is used for
posting topics related to SDR software development and experimentalist who are
using alpha and beta versions of the software.
